Finally Back in the Body Shop

 Darrell has had a tough time with health issues, causing delays on getting moving on the body work and paint.  Today we delivered the running chassis to Darrell to have the body work and painting done.

We are really glad to see Darrell getting back to work, both personally and professionally.  He's become a good friend over the years.  Here's some pics as we delivered the running chassis, Darrell has sure lost a lot of weight!





Comments

Post a Comment

Popular posts from this blog

Almost Done, Beauty Shots!

Image
 Been installing more parts, we think we've got everything in place now except for the new top.  We have to wait on the header rail sockets, which are on back order. We've also started driving the car to find the inevitable problems when you assemble a complex device like a car.  Three problem areas found so far. First is the thermostat was installed upside down: This results in no flow at all.  Fortunately we were close to the shop when the temperature went way high.  This was easy to correct. Second was the wrong ignition coil was installed.  Due to being installed upside down, you couldn't see that the high tension wire from the center of the coil was the push in style, but the coil itself was made for the screw in type connector.  The rubber boot was holding the wire in place.  It fell off about 3 blocks from the shop, resulting in a dead car.  Fortunately there were some downhill portions as we pushed the car back to the shop, easy diagn...
Read more

Waiting on Body Work

Image
 Darrell is running way behind on body work.  Maybe just as well, Ray's in FL for most of the winter and Vince is headed there soon.  But meantime there are some bench projects being undertaken. The windshield glass is overall in good shape except for a small crack in the lower passenger side corner.  Initial thought was to glue it back together, but the windshield glue we had was dried out.  So instead we separated the corner by removing two screws from that corner and inserted small pieces of rubber tubing behind the loose piece of glass, which holds it in place probably better than glue anyway.  Here's come pictures: This should work fine. The heater box was cleaned up and painted, plus the blower motor confirmed to work.  The heater box had some kind of light undercoating type material on it, we cleaned it up some before painting: Then the wiper motor and mechanism was cleaned up and lubricated and confirmed to work.  The red wire that "parks"...
Read more

Lot of Progress for only 7 days!

Image
 Had lots of help earlier this week, until the holidays and extreme cold weather hit the last 2 days! Dave from our club was helping.  Even had the owner Eric stop by and put him to work for a while! The windshield and cockpit trim are installed.  Fender "welting" is installed and fenders in final position.  Carpet set is over half way done.  Interior door panels are done, some smaller panels yet to go.   Hope to place a parts order early next week, don't want to he held up waiting on parts!
Read more